Allegion

 
This product should only be installed, used and maintained in accordance with relevant local regulations.  The following points are for guidance only and are in no way intended as a substitute for the above mentioned regulations.
  • Risk assessments should be carried out prior to installation.
  • Ensure the power is off and battery is disconnected (disconnect wires at Battery Socket SKT8, see drawing E352), when access lid is open
  • Take reasonable precautions before lifting any heavy material.
  • Install the product as illustrated in the Installation Instructions.
  • Wear appropriate protective clothing and footwear, i.e. safety boots.
  • Product should only be used in accordance with Allegion instructions contained herein and in other official Allegion documents as applicable.
  • Ensure chassis earth tag is connected to good incoming earth.
  • This unit should be connected to a "Fused Spur" fitted with 1" x 1/4" BS1362 HBC Ceramic fuse rated at 3A, where a fused spur is not used the unit must be protected with a quick blow 3A 250V High Breaking Capacity (HBC) Ceramic Fuse.
  • Product should not be installed in locations were extreme conditions are present, such locations may include the following;
     
    • Environments where excessive dust, moisture, vibration, flammable gases are present, also those with corrosive or explosive atmospheres.
    • In vehicles, on board ships or aircraft, in tropical countries or at altitudes greater than 2000m
    • Where ingress of water is possible, e.g. if the product is installed on the outside of a building it should be sheltered from the elements.

Download the installation manual here.

To request literature or a call back please contact us.